---
id: connect-your-obu
type: task
title: Connect your OBU
summary: With the car on, go to Settings › OBU (ERP 2.0), make sure Setup is done, tap Connect, search for your OBU and enter your iPhone's Bluetooth address on LTA's screen the first time. After that Kerbside reconnects by itself.
section: start
url: "https://irrhuh.app/kerbside/guide/connect-your-obu.html"
related: [obu-page, troubleshooting, getting-started, obu-and-erp]
platform: [iphone]
applies_to: 1.0
updated: 2026-11-16
---

# Connect your OBU

You connect Kerbside to your car's OBU once. After that it reconnects by itself whenever you open the app or switch the car on. The first connection takes a few minutes.

## Before you start

- **The car must be on**, with the OBU powered.
- **The OBU talks to one app at a time.** Disconnect LTA's ERP 2.0 app, Breeze or any similar app first.
- **Register your iPhone's Bluetooth address** with LTA (e-Services, up to 5 phones per OBU). Find the address in iOS **Settings › General › About › Bluetooth**. Long-press the row to copy it.
- **Internet** on the iPhone: LTA's software needs it to connect.

## Step 1: finish Setup

1. Open Settings › **OBU (ERP 2.0)**.
2. Under **Setup**, check both rows have a tick:
   - **Initialise SDK** is normally ticked already, because it runs when Kerbside opens.
   - **Grant OBU data permission**: tap it. LTA's own screen asks once for permission to read OBU data. Allow it.

If you skip this, the Connect screen says "Finish Setup first: initialise the SDK and grant the OBU data permission."

## Step 2: find and connect your OBU

1. On the same page, tap **Connect**. The **Connect an OBU** screen opens.
2. Tap **Search for OBUs nearby**. The search runs for up to 60 seconds.
3. Your OBU appears with its own number, like `OBU-1234567890`. Tap it, or its **Connect** button.
4. **The first time only**, LTA's screen asks for your iPhone's Bluetooth MAC address. Paste the address you copied from iOS **Settings › General › About › Bluetooth**. It has to be the address you registered with LTA.
5. Keep the car on and the screen open. Pairing usually takes 10–20 seconds. You'll see "Connected to …", and the screen closes by itself 2 seconds later.

The OBU is now saved under **My OBUs**.

## Step 3 (recommended): add a name and plate

1. In Settings › OBU (ERP 2.0) › **My OBUs**, tap your OBU.
2. Enter a **Name** (for example "Family car") and your **Car plate**.
3. Go back to save.

With a plate saved, Kerbside reconnects straight away without searching. Both stay on your iPhone.

## If it doesn't connect

- After 45 seconds with no answer, Kerbside suggests checking iOS **Settings › Bluetooth**. If the OBU shows as Connected there while Kerbside isn't, another app or iOS is holding it: close that app, or tap ⓘ › **Forget This Device** in iOS Settings, then tap **Stop and try again**.
- "Bluetooth MAC address not registered": the address you entered isn't registered with LTA for this OBU.
- More fixes: [The OBU won't connect](https://irrhuh.app/kerbside/kb/troubleshooting.html#the-obu-wont-connect).
