Therbie Help
iPhone and iPad

Light meter

The Light Meter in Therbie estimates how bright a scene is, using the camera. iPhones and iPads have a light sensor for screen brightness, but iOS doesn't let apps read it.

How it works: the camera picks its own exposure (aperture, shutter time and ISO). From that, and how bright the picture comes out, Therbie works out how bright the scene is.

No photo or video is taken or kept. Each frame is read for its exposure and average brightness, then dropped at once.

Turn it on

  1. Go to the Measure tab and tap the Light Meter tile. Measure › Start › Light opens it too.
  2. The first time, a sheet explains the sensor and shows its settings. Tap Turn On.
  3. Allow the camera when iOS asks.

After that, a tap on the tile turns the Light Meter on, and the tile's power button turns it off. When it's on, tap the tile to open the meter full screen. The camera starts when you open the meter and stops when you close it, unless logging keeps it running (see below).

The meter

PanelWhat it shows
BrightnessThe estimated illuminance in lux, the exposure value (EV at ISO 100), everyday words for it, and the camera's own aperture, shutter time and ISO. There's a night-to-sun scale and a small live preview of what the camera sees
Colour temperatureHow warm or cool the light is, in kelvin, estimated from the camera's white balance, on a 2,000 to 10,000 K scale
Exposure for this lightThe shutter speed for a mid-grey exposure at f/1.8, f/2, f/2.8, f/4, f/5.6, f/8, f/11 and f/16, at ISO 100 and ISO 400, to the nearest third of a stop. "> 1/8000" or "> 30″" means the light is too bright or too dark for that setting
  • Hold (top left) freezes the reading, for example so you can note the exposure. Release goes live again.
  • Camera (top left) switches between Back camera and Front camera. The same choice is in the settings.

How it's worked out

  • EV at ISO 100 = log2(N² / t) − log2(ISO / 100), where N is the f-number and t the shutter time in seconds.
  • Correction: the camera tries to make every scene mid-grey. When the picture comes out brighter or darker than that, Therbie corrects the EV by up to 3 stops.
  • Lux ≈ 2.5 × 2^EV.

To save battery, the camera runs at a low resolution (640 × 480) and 15 frames a second.

Accuracy

This is an estimate of reflected light: what the camera sees. A hand-held lux meter measures the light falling on a spot, which is different. Point the camera at a white wall and then a dark sofa under the same lamp, and you'll get different readings.

For the fairest reading, point it at a mid-toned or mixed scene, or hold a grey card in front of it. Readings are good for comparing rooms, times of day and lamps, and for the exposure table. They aren't calibrated.

What's logged

Log to History, under Light Meter in ⋯ › Sensors, has four choices:

ChoiceWhat happens
OffNothing is logged. The camera runs only while the meter is open
Every minute or Every 2 minutesWhile Therbie is on screen, the camera comes on for about 3 seconds and logs one reading
ContinuouslyWhile Therbie is on screen, the camera stays on and Therbie logs the average, brightest and dimmest lux every second

Nothing is logged while Therbie is off screen: the Light Meter has no background logging. Logged readings go to a Mac you've paired, with History.

Battery

The camera uses a lot of power, so the Light Meter's battery use is High while the camera runs.